guides:virtual_modem:section_4:changing_the_serial_port
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
|
guides:virtual_modem:section_4:changing_the_serial_port [2018-09-23 01:51] omolini [Update vmodem.sh script] |
guides:virtual_modem:section_4:changing_the_serial_port [2018-09-23 01:52] omolini [Update vmodem.sh script] |
||
|---|---|---|---|
| Line 14: | Line 14: | ||
| ===== Update vmodem.sh script ===== | ===== Update vmodem.sh script ===== | ||
| - | * To update the **vmodem.sh** script stored in **/boot/vmodem/**, do the following: | + | * To change the serial port used in the **vmodem.sh** script, do the following: |
| * Run ''sudo nano /boot/vmodem/vmodem.sh'' | * Run ''sudo nano /boot/vmodem/vmodem.sh'' | ||
| - | * Find the line **serport=ttyUSB0** and update it to reflect the correct serial device. | + | * Find the line ''serport=ttyUSB0'' and update it to reflect the correct serial device. |
| * For example, if your USB device is called "/dev/ttyAMA0", then make sure the line says ''serport=ttyAMA0''. | * For example, if your USB device is called "/dev/ttyAMA0", then make sure the line says ''serport=ttyAMA0''. | ||
| * Save file by pressing **CTRL + o**, then ENTER to save under the same name. | * Save file by pressing **CTRL + o**, then ENTER to save under the same name. | ||
guides/virtual_modem/section_4/changing_the_serial_port.txt · Last modified: 2019-08-22 18:24 by omolini
Page Tools
